2006 Yamaha Motorsports Attak Owners Manual - Page 69
2006 Yamaha Motorsports Attak Manual
Page 69 highlights
4. Start the engine, allow it to idle for several minutes, and then turn it off. 5. Check the coolant reservoir. If it is not full, remove the coolant reservoir cap, fill the reservoir with the recommended coolant, and then install the cap. 6. Check for any coolant leakage. NOTE: @ If you find any leaks, consult a Yamaha dealer. @ 7. Install the top cover. ESU04550 Replacing the V-belt WARNING @ When installing the new V-belt, make sure it is positioned from 1.5 mm (0.06 in) above the edge of the secondary sheave assembly to 0.5 mm (0.02 in) below the edge a. If not, the V-belt clutch engagement speed will be changed. The snowmobile may move unexpectedly when the engine is started. Adjust the V-belt position by removing or adding a spacer 1 on each adjusting bolt. Have a Yamaha dealer make this adjustment. @ CAUTION: @ As the V-belt wears, adjustment may be necessary. To ensure proper clutch performance, the V-belt position should be adjusted by adding a spacer on each adjusting bolt when the V-belt position reaches 1.5 mm (0.06 in) below the edge. Have a Yamaha dealer make this adjustment. @ CD-05E New belt width Belt wear limit width 34.5 mm (1.36 in) 32.5 mm (1.28 in) NOTE: @ Apply the parking brake before replacing the V-belt. @ 8-16