2011 Yamaha Motorsports Phazer GT Owners Manual - Page 43
2011 Yamaha Motorsports Phazer GT Manual
Page 43 highlights
Operation ESU13500 Read the Owner's Manual carefully to become familiar with all controls. If there is a control or function you do not understand, ask your Yamaha dealer. EWS00201 WARNING Failure to familiarize yourself with the controls can lead to loss of control, which could cause an accident or injury. ESU13212 2. TIP This model is equipped with: G an engine oil pressure switch to stop the engine in case an engine oil pressure drop is detected. To start the engine after this system has stopped the engine, be sure to place the snowmobile on a level surface, and then turn the key in the main switch to the off position, and then to the on position. Failing to do so will prevent the engine from starting even though the engine will crank when turning the key to the start position. If the engine does not start or if it stops again, ask a Yamaha dealer to inspect the snowmobile. G an engine overheating prevention system, which prevents overheating when the engine is idling. When the engine has been idling for 3 minutes or longer and the coolant temperature has risen above 100 °C (212 °F), the engine automatically stops to prevent overheating. The engine can be started after it stops. ESU11303 Be sure the engine stop switch is in the run position. The starter motor cannot be operated when the engine stop switch is in the off position. 1 2 1. Run position 2. Off position 3. Turn the main switch to the start position and release it when the engine starts. NOTICE: Release the switch immediately after the engine starts. If the engine fails to start, release the switch, wait a few seconds, then try again. Each attempt should be as short as possible to preserve the battery. Do not crank the engine more than 10 seconds on any one attempt. [ECS00331] Starting the engine 1. Apply the parking brake. 37