2012 Yamaha Motorsports Raider SCL Owners Manual - Page 23
2012 Yamaha Motorsports Raider SCL Manual
Page 23 highlights
INSTRUMENT AND CONTROL FUNCTIONS Right and for approximately 15 seconds. However, the turn signal lights can also be canceled manually by pushing the switch in after it has returned to the center position. TIP The self-canceling system only operates when the vehicle is moving, so that the turn signal lights will not self-cancel while you are stopped at an intersection. EAU12500 EAU12400 Push this switch to the left to turn the optional lights on and to the right to turn them off. ECA15321 NOTICE Do not install a bulb which exceeds 12 V, 35 W in either light, otherwise the headlight fuse may blow or the battery may discharge. EAU12711 1. Engine stop switch " / " 2. Light switch (for optional lights) " 3. Start switch " " " Dimmer switch " / " Set this switch to " " for the high beam and to " " for the low beam. EAU12430 Horn switch " " Press this switch to sound the horn. EAU12660 Start switch " " Push this switch to crank the engine with the starter. See page 6-1 for starting instructions prior to starting the engine. EAU41700 4 Turn signal switch " / " To signal a right-hand turn, push this switch to " ". To signal a left-hand turn, push this switch to " ". When released, the switch returns to the center position. Since this model is equipped with a self-canceling system, the turn signal lights will self-cancel after the vehicle has traveled both about 150 m (490 ft) Engine stop switch " / " Set this switch to " " before starting the engine. Set this switch to " " to stop the engine in case of an emergency, such as when the vehicle overturns or when the throttle cable is stuck. EAU38331 The engine trouble warning light will come on when the key is turned to "ON" and the start switch is pushed, but this does not indicate a malfunction. EAU44602 Light switch (for optional lights) " " This model can be equipped with optional lights available at a Yamaha dealer. 4-6 "SELECT" switch This switch is used to perform selections in the odometer and tripmeters, to set the clock and to set the brightness control mode of the multi-function meter unit.