2012 Yamaha Motorsports Raider SCL Owners Manual - Page 54
2012 Yamaha Motorsports Raider SCL Manual
Page 54 highlights
PERIODIC MAINTENANCE AND ADJUSTMENT ECA10900 NOTICE Make sure that the oil filler cap is securely tightened, otherwise oil may seep out when the engine is running. To change the engine oil (with or without oil filter cartridge replacement) 1. Place the vehicle on a level surface. 2. Remove the rider seat. (See page 4-12.) 3. Start the engine, warm it up for several minutes, and then turn it off. 4. Place an oil pan under the oil tank to collect the used oil. 5. Remove the engine oil filler cap, the engine oil drain bolt and its gasket to drain the oil from the oil tank. 2 1 1. Maximum level mark 2. Minimum level mark 3. Engine oil dipstick 1. Engine oil drain bolt (oil tank) 2. Gasket 5. If the engine oil is at or below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. 7 TIP When adding oil, be careful not to overfill the engine oil tank; the oil level rises faster starting from the half level portion on the dipstick. 6. Insert the dipstick into the oil filler hole, and then tighten the oil filler cap. 7. Install the rider seat. 6. Place an oil pan under the engine to collect the used oil. 7. Remove engine oil drain bolts A and B, and their gasket to drain the oil from the crankcase. 3 2 1 1. Engine oil drain bolt A (crankcase) 2. Engine oil drain bolt B (crankcase) 3. Gasket 7-11