3M X75 Operation Guide - Page 38
OPTION Menu
View all 3M X75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Multifunctional settings OPTION Menu With the OPTION menu, items shown in the table below can be performed. Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table. MENU [RGB] :SELECT PICTURE ONETOUCH IMAGE AUTO SEARCH TURN OFF VIDEO Qlty. AUTO OFF 0 INPUT LAMP TIME 0 SETUP FILTER TIME 0 SCREEN SERVICE OPTION NETWORK EASY MENU Item ONE TOUCH AUTO SEARCH Description Using the buttons ▲/▼ turns on/off the automatic keystone correction function. TURN ON TURN OFF You can automatically correct vertical keystone distortion corresponding to the angle (forward/backward tilt) at which the unit is set up. This function works with ONE TOUCH operation. • If the projection screen is inclined, or if the projector is angled downwards, it may not be possible to make the correct adjustment when V: INVERT or H&V: INVERT is selected under the MIRROR item of the SETUP menu. • When the zoom adjustment is set to the TELE side, automatic correction may be excessive. The automatic correction function should be used with zoom set to WIDE whenever possible. Using the buttons ▲/▼ turns on/off the automatic signal search function. TURN ON TURN OFF This function works with INPUT, RGB, and VIDEO buttons. When the TURN ON is selected, detecting no signal automatically cycles through input ports in order of following. The search is started from the current port. Then when an input is found, the projector will stop searching and display the image. RGB IN1 RGB IN2 DVI-D COMPONENT VIDEO S-VIDEO VIDEO AUTO OFF Using the buttons ▲/▼ adjusts the time to count down to automatically turn the projector off. Long (max. 99 minutes) Short (min. 0 minute = DISABLE) AUTO OFF ENABLE 1 AUTO OFF DISABLE 0 When the time is set to 0, the projector is not turned off automatically. When the time is set to 1 to 99, and when the passed time with a no-signal or an unsuitable signal reaches at the set time, the projector lamp will go off and the power indicator begins blinking. Please refer to the section "Turning off the power" (16). 38