3M X75 Safety Guide - Page 7
Caution - ceiling mount
View all 3M X75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH CAUTION • To reduce the risk associated with environmental contamination: - Dispose of exhausted batteries in accordance with applicable federal, state and local regulations. • To reduce the risk associated with environmental contamination due to mercury: - Dispose of lamp cartridge in accordance with applicable federal, state and local regulations. • To reduce the risk associated with laser radiation, which if not avoided may result in minor or moderate injury: - Never look directly at the laser output of the remote control or point it at other people. - Never attempt to make any adjustments to the internal controls of the remote control other than those described in the Operator's Guide. • To reduce the risk associated with explosion, and/or chemicals from a leaking battery: - Use only with battery type AA or equivalent. - Orient the battery's plus (+) and minus (-) terminals of the batteries according to the markings found on the remote control. - Do not leave the battery in the remote for an extended period of time. - Do not heat, disassemble, short, recharge, or expose to fire or high temperature - Do not carry batteries loose in your pocket or purse. - Avoid eye and skin contact in the event that battery would leak - Do not mix used and new batteries. • To reduce the risk associated with the hot surface of exhaust loovers: - Do not touch exhaust loovers during operation. • To reduce the risk associated with the impact of a falling projector: - Use only the 3M™ brand wall/ceiling mounting hardware kit if wall or ceiling mounting is desired. - Installation of the 3M™ wall/ceiling kit must only be performed by qualified personnel. - Adhere strictly to the proper installation procedure as outlined in the installation instructions when installing the 3M™ wall/ceiling kit. - Always operate the unit on a flat, sturdy, and horizontal surface. • To reduce the risk associated with intense visible light: - Avoid looking directly into the projector lens while the lamp is on. • To reduce the risk associated with tripping and/or impact: - Position the power cord and data cable so that they cannot be tripped over. © 3M 2005 3M™ Multimedia Projector X75 Product Safety Guide 7