AEG AGS58210F0 Product Manual - Page 12

12 www.aeg.com Problem Possible cause Solution The compressor operates continually. Temperature is set incorrect- Refer to "Operation" chap- ly. ter. Many food products to be frozen were put in at the same time. Wait some hours and then check the temperature again. The room temperature is too Refer to climate class chart high. on the rating plate. Food products placed in the Allow food products to cool appliance were too warm. to room temperature before storing. The door is not closed cor- Refer to "Closing the door". rectly. The FROSTMATIC function Refer to "FROSTMATIC is switched on. function". There is too much frost and ice. The door is not closed correctly or the gasket is deformed/dirty. Refer to "Closing the door". The water drainage plug is Position the water drainage not correctly positioned. plug in the correct way. Food products are not wrap- Wrap the food products bet- ped properly. ter. Temperature is set incorrect- Refer to "Operation" chap- ly. ter. The compressor does not start immediately after pressing the FROSTMATIC, or after changing the temperature. This is normal, no error has occurred. The compressor starts after a period of time. Temperature cannot be set. The FROSTMATIC or COOL- Switch off FROSTMATIC or MATIC function is switched COOLMATIC manually, or on. wait until the function resets automatically to set the tem- perature. Refer to "FROST- MATIC or COOLMATIC function". The temperature in the ap- The temperature regulator is Set a higher/lower tempera- pliance is too low/too high. not set correctly. ture. The door is not closed cor- Refer to "Closing the door". rectly.