AEG AGS58210F0 Product Manual - Page 13
Installation
![]() |
View all AEG AGS58210F0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH 13 Problem Possible cause Solution The food products' tempera- Let the food products tem- ture is too high. perature decrease to room temperature before storage. Many food products are stored at the same time. Store less food products at the same time. The thickness of the frost is Defrost the appliance. greater than 4-5 mm. The door has been opened Open the door only if neces- often. sary. The FROSTMATIC function Refer to "FROSTMATIC is switched on. function". There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance. If the advice does not lead to the desired result, call the nearest Authorized Service Centre. 8.2 Closing the door 1. Clean the door gaskets. 9. INSTALLATION 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. WARNING! Refer to Safety chapters. 9.1 Location Refer to the assembly instructions for the installation. To ensure best performance, install the appliance well away from sources of heat such as radiators, boilers, direct sunlight etc. Make sure that air can circulate freely around the back of the cabinet. 9.2 Positioning This appliance can be installed in a dry, well ventilated indoor where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate Ambient temperature class SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C
![](/manual_guide/products/aeg-ags58210f0-product-manual-1d67cae/13.png)