AEG AutoSense Freestanding 60cm Washing Machine White L68480FL Product Manual - Page 19
Troubleshooting
View all AEG AutoSense Freestanding 60cm Washing Machine White L68480FL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ENGLISH 19 3. 4. 45° 20° 12.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. When you drain the water with the emergency drain procedure, you must activate again the drain system: Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water 12.9 Frost precautions If the appliance is installed in an area where the temperature can be less than 13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the Authorised Service Centre. 0° C, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Put the two ends of the inlet hose in a container and let the water flow out of the hose. 4. Empty the drain pump. Refer to the emergency drain procedure. 5. When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water properly. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. Please check the door! • - The mains supply is unstable. Wait until the mains supply is stable.