AEG AutoSense Freestanding 60cm Washing Machine White L68480FL Product Manual - Page 21
Problem, Possible solution
View all AEG AutoSense Freestanding 60cm Washing Machine White L68480FL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
ENGLISH 21 Problem Possible solution The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it. You cannot open the ap- Make sure that the washing programme is finished. pliance door. Set the drain or the spin programme if there is water in the drum. The appliance makes an Make sure the levelling of the appliance is correct. Refer to 'In- unusual noise. stallation'. Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation'. Add more laundry in the drum. The load may be too small. The cycle is shorter than The appliance calculates a new time according to the laundry the time displayed. load. See the 'Consumption Values' chapter. The cycle is longer than An unbalanced laundry load increases the duration time. This the time displayed. is a normal behaviour of the appliance. The washing results are Increase the detergent quantity or use a different detergent. not satisfactory. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. You cannot set an option. Make sure that you press only the wanted button(s). After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre.