AEG DynamicAir Freestanding 59.5cm Refrigerator Stainless Steel S63300KDX0 Pro - Page 12
Replacing the lamp, Closing the door
View all AEG DynamicAir Freestanding 59.5cm Refrigerator Stainless Steel S63300KDX0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 www.aeg.com Problem Water flows on the ground. The temperature in the appliance is too cold. The temperature in the appliance is too warm. The temperature in the refrigerator is too warm. The appliance does not operate. The lamp does not work. Door interferes with ventilation grill. Misaligned door. Possible cause Solution The melting water outlet Attach the melting water does not flow in the evap- outlet to the evaporative orative tray above the tray. compressor. The Temperature regula- Set a warmer temperature. tor may be set incorrectly. The Temperature regula- Set a lower temperature. tor may be set incorrectly. The door is not closed correctly. Refer to "Closing the door". The food temperature is too high. Let the food temperature decrease to room temperature before storage. There is no cold air circu- Make sure that there is lation in the appliance. cold air circulation in the appliance. Large quantities of food Insert smaller quantities of to be cooled were put in food to be cooled at the at the same time. same time. The appliance is switched Switch on the appliance. off. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a another electrical appliance to the mains socket. Check fuse. Contact a qualified electrician. The lamp is defective. Refer to "Replacing the lamp". The door has been open Close the door. to long. The appliance is not lev- Refer to "Levelling". elled. The appliance is not lev- Refer to "Levelling". elled. As much as the advice does not lead to result, call the nearest brand-mark service. 7.1 Replacing the lamp 7.2 Closing the door The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Service Center . 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation".