AEG L69470VFL Product Manual - Page 14

14 www.aeg.com If you set something incorrect, the display shows the message . 10.7 Starting a programme without the Finish In option Touch the button Start/Pause . • The indicator of the button Start/ Pause stops to flash and stays on. • The programme starts, the door locks, the indicator is on. • The drain pump can operate for a short time at the beginning of the washing cycle. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 10.8 Starting a programme with the Finish In option 1. Touch the button Finish In again and again to choose the number of hours in which you want the washing cycle to be finished. The display shows the number of hours you set (e.g. ) and the indicator above the button Finish In is on to show that his option is active. 2. Touch the button Start/Pause : • The door is locked. • The appliance starts the countdown. • When the countdown is completed, the programme starts automatically. You can cancel or change the set of the Finish In option before you touch the button Start/Pause . After touching the button Start/ Pause you can only cancel the Finish In option. To cancel the Finish In option: a. Touch the button Start/Pause to set the appliance to pause. The indicator of button Start/Pause flashes. b. Touch the button Finish In until the indicator above this button goes off. Touch the button Start/Pause again to start the programme immediately. 10.9 Interrupting a programme and changing the options You can change only some options before they operate. 1. Touch Start/Pause . The indicator of this button flashes. 2. Change the options. If you change any option the Finish In option (if set) will be disabled. 3. Touch Start/Pause again. The programme continues. 10.10 Cancelling a running programme 1. Press the button On/Off for some seconds to cancel the programme and to deactivate the appliance. 2. Press the same button again to activate the appliance. Now, you can set a new washing programme. Before starting the new programme the appliance could drain the water. In this case, make sure that the detergent is still in the detergent compartment, if not fill the detergent again. 10.11 Opening the door While a programme (or the Finish In) operates, the appliance door is locked. The indicator is on. CAUTION! If the temperature and level of the water in the drum are too high, you cannot open the door.