AEG L7FEE965R User Manual - Page 30
Cleaning the inlet hose, and the valve filter, Emergency drain, Frost precautions
View all AEG L7FEE965R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
30 www.aeg.com 12.8 Cleaning the inlet hose and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter. 45° 20° 1 2 3 2. Remove the inlet hose from the appliance by loosening the ring nut. 3. Clean the valve filter on the back of the appliance with a toothbrush. 4. When you reconnect the hose to the back of the appliance, turn it left or right (not in vertical position) depending on the position of your water tap. 12.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. 12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Put the two ends of the inlet hose in a container and let the water flow out of the hose. 4. Empty the drain pump. Refer to the emergency drain procedure. 5. When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is higher than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures.