AEG L87405FL Product Manual - Page 25
Problem, Possible solution
View all AEG L87405FL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
ENGLISH 25 Problem Possible solution The appliance does not fill with water and drain immediately. Make sure that the drain hose is in the correct position. The hose may be too low. The appliance does not Make sure that the sink spigot is not clogged. drain the water. Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct. Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it. You cannot open the ap- Make sure that the washing programme is finished. pliance door. Set the drain or the spin programme if there is water in the drum. Make sure that the appliance receives electrical power. This problem may be caused by a failure of the appliance. Contact the Authorised Service Centre. If you need to open the door, please read carefully «Emergency door opening». The appliance makes an Make sure the levelling of the appliance is correct. Refer to 'In- unusual noise. stallation'. Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation'.