AEG L87494EFL Product Manual - Page 25

12. TROUBLESHOOTING ENGLISH 25 The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on. WARNING! Deactivate the appliance before you do the checks. Problem Possible cause Possible solution The appliance does not fill with water. The water tap is closed. Open the water tap. The water inlet hose is Make sure that the water inlet damaged. hose has no damages. The filters in the water Clean the filters. Refer to 'Care inlet hose is blocked . and cleaning'. The water tap is blocked Clean the water tap. or is furred with limescale. The connection of the water inlet hose is not correct. Make sure that the connection is correct. The water pressure is too low. Contact your local water authority. The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain pump is blocked. Clean the filter of the drain pump. Refer to 'Care and cleaning'. The connection of the water drain hose is not correct. Make sure that the connection is correct. A washing programme Set the drain programme. without the drain phase is set. The function Rinse & Hold is on. Set the drain programme. The appliance door is open or not closed correctly. Close the door correctly.