AEG SKD71800C0 Product Manual - Page 14

14 www.aeg.com As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter "E" or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter "N" or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the "L" or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 5. Switch on the appliance. The appliance is supplied with a 13 amp fuse (B). In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. 8.3 Ventilation requirements The airflow behind the appliance must be sufficient. 5 cm min. 200 cm2 min. 200 cm2 CAUTION! Refer to the assembly instructions for the installation. 9. NOISES There are some sounds during normal running (compressor, refrigerant circulation). OK SSSRRR! HISSS! BLUBB! CLICK! BRRR! CRACK!