AEG T6DBG820N User Manual - Page 14
Hints And Tips
View all AEG T6DBG820N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 www.aeg.com Child lock option activation: 1. Turn the dryer on. 2. Select 1 of the available programs. 3. Touch and hold down 2 buttons at the same time. The symbol appears on the display. 4. To deactivate the child lock, touch the above buttons again until the symbol disappears. 8.8 Starting a program To start the program: Touch the Start/Pause button. The appliance starts and the LED above the button stops flashing and stays on. 8.9 Program change To change a program: 9. HINTS AND TIPS 9.1 Ecological hints • Spin the laundry well before drying. • Do not exceed the load sizes which are specified in the programs chapter. • Clean the filter after each drying cycle. • Do not use fabric softener to wash and then dry. In the tumble dryer laundry becomes soft automatically. • Use distilled water like that used for steam ironing. If it is necessary, clean 1. Push the On/Off button to turn the appliance off. 2. Push the On/Off button again to turn on the appliance. 3. Set a new program. 8.10 Program end Clean the filter and drain the water container after each drying cycle. (See chapter CARE AND CLEANING.) If the drying cycle is finished, the symbol appears on the display. If the Buzzer option is activated, the acoustic signal sounds intermittently for 1 minute. If you do not turn off the appliance, the anti-crease phase starts (not active with all programs). Flashing symbol signals the execution of the anticrease phase. Laundry can be removed during this phase. To remove the laundry: 1. Push the On/Off button for 2 seconds to turn the appliance off. 2. Open the appliance door. 3. Remove the laundry. 4. Close the appliance door. the distilled water before (e.g. with a coffee filter) to remove any particles. • Always keep the airflow slots at the bottom of the appliance clear. • Make sure there is good airflow where the appliance is to be installed. 9.2 Adjustment of default dryness level To change the default dryness level: 1. Turn the appliance on.