AEG T6DBG820N User Manual - Page 4

4 www.aeg.com • The appliance can be installed as freestanding or below the kitchen counter with correct space (Refer to the Installation leaflet). • Do not install the appliance behind a lockable door, a sliding door or a door with a hinge on the opposite side, that would prevent the appliance door from being fully opened. • The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. • WARNING: The appliance must not be supplied through an external switching device, such as timer, or connected to a circuit that is regularly switched on and off by a utility. • Connect the mains plug to the mains socket only at the end of the installation process. Make sure that the mains plug is accessible after installation. • Ensure good air ventilation in the located room to avoid the backflow of unwanted gases into the room from appliances burning gas or other fuels, including open fires. • Exhaust air must not be discharged into a flue which is used for exhausting fumes from any appliances burning gas or other fuels. • If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. • Do not exceed the maximum load of 8 kg (refer to the "Programme chart" chapter). • Do not use the appliance if items have been soiled with industrial chemicals. • Wipe away lint or packaging debris that has accumulated around the appliance. • Do not run the appliance without a filter. Clean the lint filter before or after each use. • Do not dry unwashed items in the tumble dryer.