AEG T7DBG840N User Manual - Page 22

22 www.aeg.com Possible cause Possible cause Remedy Internal fail. No communication be‐ The programme was not finished tween electronic elements of the properly or the appliance stoped appliance. too early. Switch the appliance off E97 and on again. If the alarm code appears again, contact the Authorised Service Centre. The mains supply is unstable. When the appliance is showing EH0, please wait until main supply is stable than press start. If the ap‐ EH0 pliance pause the cycle without any indication then press the cycle start. If the warning will occur check the power cord / socket in‐ tegrity or main supply. If the display shows other alarm codes, deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. In case of different problem with the Tumble dryer check the table below for possible solutions. 11.2 Troubleshooting Problem Possible cause Remedy The tumble dryer is not connected Connect it to the mains socket. to the mains supply. Check the fuse in the fuse box (do‐ mestic installation). The tumble dry‐ er does not op‐ erate. The door is open. Close the door. The On/Off button was not pushed. Push the On/Off button. The Start/Pause button was not touched. Touch the Start/Pause button. The appliance is in standby mode. Push the On/Off button.