AIWA CDC-X227 Operating Instructions - Page 4
Radio Operation - how to set clock
View all AIWA CDC-X227 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Adjusting sound You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/ rear) and H-BASS (high bass). 1 Press SEL repeatedly to select the mode to be adjusted. Pressing SEL cycles through the modes. The selected mode's indicator flashes. 2 Turn AUDIO CONTROL to increase/decrease the level or to select on/off for the selected mode. Note Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state. Aligning the source levels (Source Level Adjuster) Volume may vary each time you change the source mode. In this case, you can align each source mode's volume to almost the same level. 1 Press SRC or BAND repeatedly to select the desired mode. 2 Press DISP while pressing SEL. "LA 0" appears in the display. 3 Turn AUDIO CONTROL to adjust the level. Note Adjust the level within 5 seconds, or the selected mode will be canceled. Restoring the factory settings 1 Turn off the unit. 2 Press and hold DISP until "LA --" appears in the display. Note You can restore the factory settings only for VOL, BASS, TRE, BAL, FAD, and H-BASS, and aligned source volume levels. Muting button beep sounds 1 Turn off the unit. 2 Press and hold SEL until "bEEP" appears in the display. 3 Turn AUDIO CONTROL to select on (level indicators appear) or off (level indicators disappear). 4 Press SEL. Setting the clock 1 Press and hold DISP until the clock indicator flashes in the display. 2 Press i (to set hour) or k (to set minute), and then turn AUDIO CONTROL. 3 Press DISP. Displaying the clock 1 Press DISP. To return to the former display, press DISP again. RADIO OPERATION Tuning in to a station (Seek/Manual Tuning) LO i/k BAND Stereo indicator Local indicator Band indicator Frequency indication 1 Press BAND repeatedly to select the desired band (FM1, FM2, FM3, AM1, or AM2). 2* Press i (to move to higher frequencies) or k (to move to lower frequencies) to tune in to a station. "ST" appears in the display when an FM station is broadcasting in stereo, and receiving conditions are good. *Seek Tuning and Manual Tuning • Press and hold i or k until seek Tuning starts. The unit locates a station automatically (Seek Tuning). • Press i or k repeatedly to search for a desired station while increasing or decreasing the frequency step by step (Manual Tuning). To stop Seek Tuning, press i or k again. 3 ENGLISH