AIWA XD-DV370 Operating Instructions - Page 12

CONNECTIONS (CONTINUED) B Connecting to a TV set and an amplifier with a Digital In jack Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with a Digital In jack. The supplied video cord is also available instead of the coaxial cord. to 21 pin scart connector TV set 21 pin scart cable (not supplied) to 21 pin scart connector Rear of the unit DIGITAL OUT DIGITAL OUT COAXIAL S-VIDEO OPTICAL OUT to DIGITAL OUT OPTICAL jack AUDIO OUT L R NTSC PAL AUTO VIDEO OUT to DIGITAL OUT COAXIAL jack Optical cord (not supplied) or Coaxial cord (not supplied) to a digital input jack to an AC power socket (AC 230 V, 50 Hz) Front speaker (L) Amplifier with a Digital In jack Front speaker (R) When your TV set is equipped with an S-video input terminal, see page 17. Set the setup menu correctly after connecting! According to the audio equipment and TV set to which the unit is connected, set the "Digital Audio Output" and "TV Aspect" of the setup menu correctly referring to the following below. See "CHANGING SETUP VALUE" on page 39 in detail. Digital Audio Output PCM 12 TV Aspect When your TV set is a conventional-screen size TV: 4:3 Letter box When your TV set is a wide-screen size TV: 16:9 Wide NOTE When the picture noise appears while copy-protected DVDs are played, connect the unit directly to a TV set. Do not connect through a VCR, TV/VCR or AV selector.