ASRock ALiveNF5-eSATA2 User Manual - Page 18

2.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! • Floppy Connector (33-pin FLOPPY1) (see p.10, No. 23) Pin1 FLOPPY1 the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.10, No. 8) PIN1 IDE1 connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATA II Connectors (SATAII_ORANGE (PORT3): see p.10, No. 10) SATAII_ORANGE (PORT3) (SATAII_BLACK (PORT2): see p.10, No. 11) (SATAII_RED (PORT1): SATAII_BLACK (PORT2) see p.10, No. 12) (SATAII_BLUE (PORT0): see p.10, No. 13) SATAII_RED (PORT1) SATAII_BLUE (PORT0) These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. SATAII_RED (PORT1) and SATAII_ORANGE (PORT3) connectors can be used for internal storage devices or be connected to eSATAII_BOTTOM and eSATAII_TOP connectors with corresponding color to support eSATAII devices. Please read "eSATAII Interface Introduction" on page 25 for details about eSATAII and eSATAII installation procedures. 18