ASRock K10N78-1394 Quick Installation Guide - Page 28

2.9 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent dam- age of the motherboard! • Floppy Connector (33-pin FLOPPY1) (see p.2/3 No. 23) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2/3 No. 8) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATA II Connectors (SATAII_1 (PORT0): see p.2/3, No. 16) (SATAII_2 (PORT1): see p.2/3, No. 13) (SATAII_3 (PORT2): see p.2/3, No. 18) (SATAII_4 (PORT3): see p.2/3, No. 12) (SATAII_5 (PORT4): see p.2/3, No. 10) (SATAII_6 (PORT5): see p.2/3, No. 11) SATAII_1 (PORT 0) SATAII_3 (PORT 2) SATAII_5 (PORT 4) SATAII_2 (PORT 1) SATAII_4 (PORT 3) SATAII_6 (PORT 5) These six Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. For K10N78-1394, SATAII_6 (PORT5) connector can be used for internal storage device or be connected to eSATAII connector to support eSATAII device. Please read "eSATAII Interface Introduction" on page 33 for details about eSATAII and eSATAII installation procedures. English 28 ASRock K10N78-1394 / K10N78 Motherboard