ASRock K8Upgrade-PCIE User Manual - Page 26
Processor Multiplier, Processor Voltage, Memory Clock, Flexibility Option, Burst Length, CAS Latency
View all ASRock K8Upgrade-PCIE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Advanced CPU Configuration Overclock Mode CPU Frequency (Mhz) PCIE Frequency (MHz) Boot Failure Guard Spread Spectrum Cool' n' Quiet Multiplier/Voltage Change Processor Maximum Multiplier Processor Maximum Voltage Processor Multiplier Processor Voltage Memory Clock Flexibility Option Burst Length CAS Latency (CL) TRCD [Auto] [200] [100] [Enabled] [Auto] [Enabled] [Manual] x11 1.550 V [x8] [1.500V] [Auto] [Disabled] [8 Beats] [Auto] [Auto] If AUTO, multiplier and voltage will be left at the rated frequency/voltage. If Manual, multiplier and voltage will be set based on User Selection in Setup. +F1 F9 F10 ESC Select Screen Select Item Change Option General Help Load Defaults Save and Exit Exit v02.54 (C) Copyright 1985-2003, American Megatrends, Inc. Processor Multiplier This item will show when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. You may set the value from [x8] up to [x25] but no higher than the value of "Processor Maximum Multiplier". For example, if the value of "Processor Maximum Multiplier" is [x11], the actual value of multiplier will be [x11] even if you set this item to a value higher than [x11]. However, for system stability, it is not recommended to adjust the value of this item. Processor Voltage This item will show when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. You may set the value from [1.550V] down to [0.800V]. However, for safety and system stability, it is not recommended to adjust the value of this item. Memory Clock This item can be set by the code using [Auto]. You can set one of the standard values as listed: [133 MHz (DDR266)], [166 MHz (DDR333)], [200 MHz (DDR400)]. Flexibility Option The default value of this option is [Disabled]. It will allow better tolerance for memory compatibility when it is set to [Enabled]. Burst Length Burst length can be set to 8 or 4 beats. 64 Bit Dq must use the 4 beats. CAS Latency (CL) Use this item to adjust the means of memory accessing. Configuration options: [Auto], [2.0], [3.0], and [2.5]. 26