ASRock M3A780GXH/128M Quick Installation Guide - Page 32

2.9 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent dam- age of the motherboard! • Floppy Connector (33-pin FLOPPY1) (see p.2 No. 31) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 12) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors (SATAII_1: see p.2, No. 17) (SATAII_2: see p.2, No. 18) (SATAII_3: see p.2, No. 20) (SATAII_4: see p.2, No. 19) (SATAII_5: see p.2, No. 22) (SATAII_6: see p.2, No. 23) SATAII_6 These six Serial ATAII (SATAII) connectors support SATAII or SATA hard disk for internal SATAII_1 SATAII_2 storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. SATAII_3 SATAII_4 SATAII_5 SATAII_6 connector can be used for internal storage device or be connected to eSATAII connector to support eSATAII device. Please read "eSATAII Interface Introduction" on page 37 for details about eSATAII and eSATAII installation procedures. eSATAII Connector This eSATAII connector (eSATAII_TOP: see p.2, No. 42) supports SATA data cable for external SATAII function. The eSATAII_TOP current eSATAII interface allows up to 3.0 Gb/s data transfer rate. 32 ASRock M3A780GXH/128M Motherboard English