Aastra CM-16 CM-16 User Guide - Page 9
Model CM-16 User Guide, CM-16 Base Unit Connections
View all Aastra CM-16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INSTALLATION 3. Plug the short 2 conductor line cord tail of the Power Adapter Assembly into the 2616 Jack. When a working port is detected and the polarity is correct (pin 3+ and pin 4- ), the center LED will blink and the left LED will turn on steady. If both LEDs are not indicating as described, stop the installation and verify the M1 port is working at the intended jack with a 2616 set. Next, verify all modular cord connections to this point are correct and making good contact. When both LEDs are indicating properly, continue at step 4. Figure 1 CM-16 Base Unit Connections Base Unit M1 PBX 2616 Jack Non-switched AC Outlet Xfer Line Cord 6 Conductor Line Cord Plug Jack Pins 1 &6 carry power form adapter Pins 3 &4 carry M1 circuit (pin 3 Power Adapter Assembly 4. Plug the power adapter transformer (Xfmr) into a non-switched 120V AC outlet. The right LED will blink for about 40 seconds as the Base Unit scans for its Handset. This indicates the radio circuit has been properly powered. Go to step 5 to link the handset. If the right LED doesn't blink, verify the AC outlet is working and that the power adapter prongs fit snugly in the outlet. Try another outlet just to be sure. Once the right LED is blinking, continue at step 5. 5. While the Base Unit is scanning (right LED blinking), connect the battery to the handset. Place the battery in the compartment and slide the door closed. The handset should initialize and remain powered for a couple of minutes, enough time to link with the Antenna Unit and allow you to place a test call. Watch the handset display. As the handset initializes, two icons will appear in the top left corner. The left icon is the battery symbol and the internal bars of the icon show the remaining charge. The other important icon that must appear is the Antenna just to the right of the battery icon. When the Antenna icon appears, place a test call. 6 Model CM-16 User Guide