Acer Aspire E360 Aspire T160/Aspire E360 Service Guide - Page 48

Onboard I/O Chip Setup Phoenix - Award BIOS CMOS Setup Utility Onboard Device Setup Onboard FDC Controller Onboard Serial Port 1 [Enabled] [3F8/IRQ4] Item Help Menu Level UART Mode Select [IrDA] UR2 Duplex Mode [Half] Onboard Parallel Port [378/IRQ7] Parallel Port Mode [SPP] ECP Mode Use DMA 3 :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help . Parameter Onboard FDC Controller Onboard Serial Port 1 UR2 Duplex Mode Onboard Parallel Port Description Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install an add-in FDC or the system has no floppy drive, select Disabled in this field. Enabled Disabled Select a logical COM port name and matching address for the serial port. Select an address and corresponding interrupt for the serial port. In an infrared port mode, this field appears. Full-duplex mode permits simultaneous twodirection transmission. Half-duplex mode permits transmission in one direction only at a time. Select the value required by the IR device connected to the IR port. Select a logical LPT port address and corresponding interrupt for the physical parallel port. Options 39 Chapter 2