Acer DV550 User Manual - Page 26

SCREEN SAVER COOLING FAN BRIGHTNESS MOTION AUTO OFF OFF :SEL +-:ADJ EXIT :RETURN MENU :EXIT MENU • {COOLING FAN} - Select {ON} to turn on the cooling fan all the time. Select {AUTO} to turn on/off the cooling fan according to the display's temperature. NOTES: • The default {AUTO} option will start running the cooling fan if the temperature of 65°C (152°F) is reached, and will keep running for 30 minutes after cooling down to the temperature of 62°C (144°F). • A temperature-warning message will be shown on the screen once the temperature reaches 79°C. All key function except [Power] key will then be disabled. • {BRIGHTNESS} - Select {ON} and the brightness of the image will be reduced to an appropriate level, and the Brightness setting in the Picture menu will become unavailable. • {MOTION} - Select the time interval ({10 ~ 900} Seconds / {OFF}) for the display to slightly expand the image size and shift the position of pixels in four directions (up, down, left, or right). SIDE BORDER COLOR Adjust the brightness of the black areas displayed on both sides of 4:3 images. CONFIGURATION3 RESET Reset all settings in the CONFIGURATION3 menu to factory preset values. 4.2.8. ADVANCED OPTION menu PIP 1 2 3 ADVANCED OPTION INPUT CHANGE TERMINAL SETTING SCAN CONVERSION COLOR SYSTEM SCAN MODE SERIAL CONTROL APM LAN SETTING ADVANCED OPTION RESET FACTORY RESET NORMAL LAN OFF :SEL SET :NEXT EXIT :RETURN MENU :EXIT MENU INPUT CHANGE Select the time for input switching as {NORMAL} or {QUICK}. NOTE: The selection {QUICK} may cause a slight noise. DV420 /DV460 /DV550 TERMINAL SETTING Select the mode to display the HDMI or DVI signal according to their signal format depending on their source device. • {DVI MODE}: Used for DVI-D signal. • Select {DVI-PC} when the source device is a PC. • Select {DVI-HD} when the source device is a video device. • {HDMI SIGNAL}: Used for HDMI signal. • Select {LIMITED} when displaying the signal that uses 16 to 235 levels of 256 levels for each R, G, and B. • Select {FULL} when displaying the signal that uses all 256 levels (from level 0 to 255). DVI-MODE HDMI SIGNAL TERMINAL SETTING DVI-PC FULL PIP 1 2 3 :SEL +-:ADJ EXIT :RETURN MENU :EXIT MENU SCAN CONVERSION Choose to enable or disable the IP (Interlace to Progressive) conversion function. • {PROGRESSIVE} - Enable the IP conversion function (recommended). Once enabled, the interlace input signal will be converted to progressive format for better display quality. • {INTERLACE} - Disable the IP function. This mode is suitable for displaying motion pictures, but it increases the chance of image retention. COLOR SYSTEM Selects the Color System depends on your input video format. The options are: {AUTO} / {NTSC} / {PAL} / {SECAM} / {4.43NTSC} / {PAL-60}. NOTE: This item is functional for VIDEO input only. SCAN MODE Change the display area of the image. • {OVERSCAN} - Display about 95% of the original size of the image. The rest of the areas surrounding the image will be cut off. • {UNDERSCAN} - Display the image in its original size. NOTE: This item is functional for HDMI-Video timing input only. SERIAL CONTROL Select the network control port. The options are: {RS-232C} / {LAN}. NOTE: If {LAN} is selected, then {RS-232C} will not be activated, even if a cable is attached, and vice versa. 19