Acer Veriton 7600G Veriton 3600G/5600G/7600G Service Guide - Page 59

Parameter Description Options Suspend Mode If system activity is not detected for the length Disabled, 1 Min, 2 Min, 4 Min, 8 of time specified in this field, all devices except Min, 12 Min, 20 Min, 30 Min, 40 CPU will be shut off. Min, 1 Hour HDD Power Down If HDD activity is not detected for the length of time specified in this field, the hard disk drive will be powered down while all other devices remain active. Disabled 1 Min through15 Min Soft-Off by PWR-BTTN This is a specification of ACPI and supported by hardware. When Delay 4 sec. is selected, the soft power switch on the front panel can be used to control power On, Suspend and Off. If the switch is pressed less than 4 sec. during power On, the system will go into Suspend mode. If the switch is pressed longer than 4 sec, the system will be turned Off. The other setting is Instant-Off, where the soft power switch is only used to control On and Off, there is no need to press 4 sec, and there is no Suspend. Delay 4 sec. Instant-Off CPU THRM-Throttling The item allows you to specify the CPU speed From 12.5% to 87.5% at 12.5% (at percentage) to which it will slow down when increment the CPU reaches the predetermined overheat temperature. Wake-Up by PCI PME These fields specify whether the system will be awakened from power saving modes when activity or input signal of the specified hardware peripheral or component is detected. Disabled Enabled FAN CONTROL This setting is used to enable/disable the fan speed control function. Enabled Disabled Power-On by Ring When Enabled, any fax/ modem activity wakes Enabled up the system from suspend mode. Disabled USB KB Wake-up from S3 This setting allows you to enter "Any Key" Disabled (max. 8 numbers) to wake up the system from Enabled S3 state. Resume by Alarm Use this option to set the date and time for your Disabled computer to boot up. Enabled Date (of month) Alarm* - Indicate month when * Set Resume by Alarm to e system will boot up. Set it to 0 if you want to Enabled, then press to boot everyday. show the range of Date and Time Time (hh:mm:ss) Alarm* - Indicate the hour, Alarm. minute and second when system will boot up. Primary IDE 0/1 The global timer is the hardware timer that Disabled Secondary IDE 0/1 counts down to the power saving modes. If the Enabled FDD, COM, LPT Port monitoring of the listed hardware peripherals or PCI PIRQ[A-D] # components is enabled, the activity of the specified peripherals or components will awaken the system or reload the original count of global timer when they are accessed. NOTE: In ACPI mode: Valid-S5 and S4. In APM mode: Valid- shutdown Chapter 2 50