Acer Veriton 7600G Veriton 7600G Service Guide - Page 57

The following table describes the parameters found in this menu. Parameter Run VGABIOS if S3 Resume Power Management (Function Enabled in APM Mode) Suspend Mode (Function Enabled in APM Mode) HDD Power Down (Function Enabled in APM Mode) Soft-Off by PWR-BTTN (Function Enabled in ACPI and APM Mode) PWRON After PWR-Fail (Function Enabled in ACPI and APM Mode) Wake-Up by PCI Card (Function Enabled in ACPI and APM Mode) Description Options Auto:BIOS decides whether the VGA BIOS should initiate or not. If the default is set to "Yes", then the VGA BIOS initiates automatically. If it is set to "No", the VGA BIOS will not initiate automatically. Auto Yes No This function allows you to set the default parameters for power-saving modes. Set it to Disable to turn off the power management function. Set it to User Define to choose your own parameters. See the Power Management Mode Table. Min Saving User Define Max Saving This item lets you set the period of time after which the system enters into Suspend mode. The Suspend mode can be Power On Suspend or Suspend to Hard Drive, and it is selected in the "Suspend Mode Option". Disabled, 1 min., 2 min., 4 min., 8 min., 12 min., 20 min., 30 min., 40 min., and 1 Hour This option lets you specify the IDE HDD idle time before the device enters the power down state. This item is independent from the power states previously described in this section (Standby and Suspend). Disabled 1 min 15 min This is a specification of ACPI and supported by hardware. When Delay 4 sec. is selected, the soft power switch on the front panel can be used to control power On, Suspend and Off. If the switch is pressed less than 4 sec. during power On, the system will go into Suspend mode. If the switch is pressed longer than 4 sec, the system will be turned Off. The other setting is Instant-Off, where the soft power switch is only used to control On and Off, there is no need to press 4 sec, and there is no Suspend. Delay 4 sec. Instant-Off Use this option to determine the manner by which the system will power on after a power failure. Former-Sts On Off Former Sts (former status) - System would return to its former running state prior to the power failure. On - System would be on full on state upon resuming from power failure. Off - System would remain off. Use PCI PME# Wake-Up system . PCI must meet PCI 2.2 specification. Enabled Disabled Power-On by Ring (Function Enabled in ACPI and APM Mode) USB KB Wake-up from S3 (Function Enabled in ACPI mode) When Enabled, any fax/ modem activity wakes up the system from suspend mode. When enabled, any USB keyboard activity wakes up the system from S3 (STR, Suspend to RAM) mode. Disabled Enabled Enabled Disabled 47 Veriton 3600(D/G)/5600(D/G)/7600(D/G)