Adaptec 1863700 User Reference - Page 20

Adaptec SCSI Card 29160LP User's Reference Configuring the Adaptec SCSI Card 29160LP with SCSISelect SCSISelect, included with the Adaptec SCSI Card 29160LP, enables you to change SCSI settings without opening the computer or handling the card. SCSISelect also enables you to low-level format or verify the disk media of your SCSI hard disk drives. The following table lists the available and default settings for each SCSISelect option. Note: The default settings are appropriate for most systems. Run SCSISelect if you need to change or view current settings, or if you would like to run the SCSI disk utilities. See the descriptions of each option starting on page 16. SCSISelect Options SCSI Bus Interface Definitions: Host Adapter SCSI ID SCSI Parity Checking Host Adapter SCSI Termination LVD/SE Connectors Boot Device Options: Boot SCSI ID Boot LUN Number1 SCSI Device Configuration: Sync Transfer Rate (MBytes/sec) Initiate Wide Negotiation Enable Disconnection Send Start Unit Command Enable Write Back Cache 2 Available Settings Default Setting 0-15 7 Enabled, Disabled Enabled Automatic, Automatic Enabled, Disabled 0-15 0 0-7 0 160, 80.0, 53.4, 40.0, 160 32.0, 26.8, 20.0, 16.0, 13.4, 10.0, ASYN Yes, No Yes (Enabled) Yes, No Yes (Enabled) Yes, No Yes (Enabled) N/C (No Change) N/C (No Yes, No Change) 14