Adaptec 2126700 Installation Guide - Page 9

Connecting Your ATA Disk Drives

Get Adaptec 2126700 - Ultra ATA Card 1233 Storage Controller PDF manuals and user guides
UPC - 760884145838
View all Adaptec 2126700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Connecting Your ATA Disk Drives The ASH-1233 adapter supports up to four ATA disk drives in a master/ slave configuration. (See Setting Jumpers on ATA Disk Drives on page 7 for more information.) Connect each ATA disk drive to the ASH-1233 adapter using the proper 40-pin IDE cable. Note: The Adaptec ASH-1233 adapter does not support Cable Select (CSEL) settings. You must change the jumper settings to set disk drives as master or slave. Connector (to Adapter) Connector (to Slave) Connector (to Master) To connect your ATA disk drives, follow the instructions for your specific drive configuration: s To install an ATA disk drive as the only device on a cable, see page 9. s To install two ATA disk drives on the same cable, see page 11. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
8
Connecting Your ATA Disk Drives
The ASH-1233 adapter supports up to four ATA disk drives in a master/
slave configuration. (See
Setting Jumpers on ATA Disk Drives
on page 7
for
more information.)
Connect each ATA disk drive to the ASH-1233 adapter using the proper
40-pin IDE cable.
Note:
The Adaptec ASH-1233 adapter does not support Cable Select
(CSEL) settings
. You must change the jumper settings to set disk
drives as master or slave.
To connect your ATA disk drives, follow the instructions for your
specific drive configuration:
■
To install an ATA disk drive as the only device on a cable, see
page 9
.
■
To install two ATA disk drives on the same cable, see
page 11
.
Connector (to Master)
Connector (to Slave)
Connector (to Adapter)