Adaptec 2170200 User Guide - Page 75
SATASelect Options, Formatting and Verifying Disk Drives, Options
View all Adaptec 2170200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Appendix C: Using the ARC Utility ● 76 SATASelect Options The following table lists the available and default settings for each SATASelect option and the description of each option. The default settings are appropriate for most systems and appear in bold type in the table. Adaptec recommends that you do not change the settings. SATASelect Options Controller Configuration Runtime BIOS Available Settings Enabled Disabled Disabled:Scan bus BBS Support Device Controller Physical Drives Display Enabled during Post Disabled SATA Configuration Write Cache Enabled Disabled DMA (1420SA only) Enabled Disabled Device Security Lock (1430SA & 1220SA Only) SMART Enabled Disabled Enabled Disabled Allow Read Ahead Enabled Disabled Description Controls the state of the BIOS at POST time. When Enabled, the HostRAID controller BIOS allows the controller to act as a bootable device. Disabling the BIOS allows another suitable HostRAID controller to act as the boot device. When BBS support is set to Device base, the system's BIOS will list each connected bootable device to the HostRAID controller as an individual entry. When BBS support is set to Controller base, the system's BIOS will only list the HostRAID controller in the system boot order. This is useful in a multi-HostRAID controller configuration. When Enabled, connected physical devices are displayed during system POST. Displaying the devices adds a few seconds to the overall POST time. Enables or disables write cache on the on legacy and non-configured drives. Write cache enabled provides maximum performance. Default is Yes to enable. Enables or disables the use of Direct Memory Access (DMA) mode for the drive. Enabled provides maximum performance. Default is Yes to enable. Enables or disables the device security lock option. When enabling this option, a Security Freeze Lock command is issued to the device. Enables or disables the predictive failure feature of the disk drive. When enabled the SMART status of the drive (Healthy or Failed) will be displayed along with the physical drive display during POST. If the drive does not support SMART, the SMART status is not displayed. Default is Yes to enable. Enables or disables the read ahead cache algorithm on the drive. Enabled provides maximum performance under most circumstances. Default is Yes to enable. Formatting and Verifying Disk Drives You can use the disk utilities to low-level format or verify your disk drives. (New disk drives are low-level formatted at the factory and do not need to be low-level formatted again.). ! Caution: Before you format a disk drive, back up all data. Formatting destroys all data on a disk drive.