Adaptec 2170200 User Guide - Page 83
Update, Verify, C:\ufi_files.
![]() |
View all Adaptec 2170200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Appendix D: Using the Adaptec Flash Utility for DOS ● 84 A:\> AFU SAVE /C 0 In the following example, the AFU saves flash contents from Controller 1 to a UFI file in C:\UFI_FILES. A:\> AFU SAVE /C 1 /D C:\UFI_FILES UPDATE The UPDATE command updates a HostRAID controller's flash components from the flash image data in a UFI file. You can use the UPDATE command to update a single HostRAID controller's flash components or to update multiple HostRAID controllers on your computer. You must restart the computer following an UPDATE command. Command Syntax The command syntax for the UPDATE command is as follows: AFU UPDATE [/C] [/D ] Command Switches For details on the /C and /D switches, see SAVE on page 83. Examples The following example shows a typical system response after an update has been performed: A:\> AFU UPDATE /C 0 Adaptec Flash Utility V1.0-0 B1406 (c)Adaptec Inc. 1999-2005. All Rights Reserved. Updating Controller 0 (Adaptec ASC-48300) Reading flash image file (Build 1406) AFU is about to update firmware on controller(s) Adaptec ASC-48300 ***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE*** This might take a few minutes. Writing Adaptec ASC-48300 (4MB) Flash Image to controller 0...OK. Verifying...OK Please restart the computer to allow firmware changes to take effect. VERIFY The VERIFY command compares the contents of each of the flash components on a HostRAID controller to the corresponding image in a UFI file and indicates whether they match. Use this command to determine whether a HostRAID controller's flash components are up-to-date when compared to a specific UFI file. Command Syntax The command syntax for the VERIFY command is as follows: AFU VERIFY [/C] [/D ] Command Switches For details on the /C and /D switches, see SAVE on page 83.
![](/manual_guide/products/adaptec-2257700r-user-guide-447fc69/83.png)