Adaptec AVA-2902E Installation Guide - Page 5
Installing Device Drivers - ava driver
View all Adaptec AVA-2902E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Step 4: Plug one end of the external SCSI cable into the host adapter's 25-pin external connector and plug the other end of the cable into either one of the connectors on the external SCSI device. 3 Terminating Plug Step 5: Enable termination on the external SCSI device, if necessary. (See the SCSI device documentation for instructions on how to install and terminate the device.) Step 6: Replace the PC cover. Connect power cables to the external device and the PC. Turn ON the external device, and then turn ON the PC. Congratulations! You have physically installed the host adapter and the external SCSI device. You may need to install host adapter drivers and other software before you can use the device. For more information, see the device manufacturer's instructions and see the next section, Installing Device Drivers. 2 Installing Device Drivers s DOS and Windows® 3.x do not have embedded driver support for the AVA-2902E/I host adapter and your SCSI device. If your PC is running under DOS or Windows 3.1, you must load these drivers yourself. If Adaptec's EZ-SCSI® software was included with your host adapter, follow the driver installation instructions in the EZ-SCSI documentation. 4 AVA-2902E/I Installation Guide Part Number: 511444-00, Rev. A Print Spec Number: 496495-00 Current Date: 3/26/97 ECN Date: 4/2/97