Adaptec P2280A User Guide - Page 64
Rebuild the UnixWare Kernel, Boot the New Kernel
View all Adaptec P2280A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Ultra160 Family Manager Set User's Guide Rebuild the UnixWare Kernel To rebuild the UnixWare kernel with the new changes, follow these steps: 1 Type the following at the # prompt and press Enter after each line: cd /etc/conf/bin ./idbuild -B Status messages appear. 2 When the kernel has been built, type the following and press Enter after each line (0 in -g0 is zero, not the letter O): cd /etc/conf/cf.d cp unix /stand/unix cd / shutdown -g0 3 Type y and press Enter when the computer asks if you really want to shut down. System Is Down should appear on the screen. The UnixWare kernel is now ready for host adapter operation. Boot the New Kernel To reboot the computer with the new kernel, follow these steps: 1 Follow the on-screen instructions (usually by pressing Enter) to reboot your computer. 2 Check the bootup messages to verify that all your installed SCSI devices are listed. If some or all of your installed SCSI devices do not appear at this time, your SCSI cables may be loose, or the SCSI device setup may not be complete. If so, go back and correct any problems before proceeding. 3 Wait for UnixWare to complete bootup with the new kernel. Refer to Troubleshooting on page 5-9 if the computer crashes or if panic (UnixWare error) messages appear during bootup. The updated driver for UnixWare should now be ready to use. 5-6