Akai LCT2701TD Operating Instructions - Page 30

cursor to "Cancel" and press Enter button for close this setting. ⰷ
Press ʻ button to return. Note: It will be invalid if the current source is not TV. Hot keys: - You can also press CH.Edit button on the remote control. ■
Selecting Channel
Ⱝ Press CH +/- button on the remote control to search the channels, the channel number will increase or decrease by 1 for each pressing excluding the skipped channels.
Ⱟ Press number buttons 0~9 to select the corresponding channel content. If the channel number is bigger than 9, just press the two number buttons successively. If the channel number is bigger than 100, just press the three number buttons successively. The time interval should not exceed 2 seconds.
ⰱ If the channel number you pressed is bigger than the maximum channel number that the setting is permitted, the maximum numbered channel content will be remained. ■
Channel Preview Press Recall button to switch between present channel and previous channel. (Only for TV) Hot keys: - You can also press Recall button on the remote control. ◆ Using the Geometric Menu Note: Ⱝ If your current input source is "VGA" , push Menu button enter into this menu. It is not available in other input source mode. Ⱟ
When smart picture mode is pre-set, the value of the above settings will be different according to different input source. ■
Using "Contrast"
Ⱝ Press Menu button on the remote control, and then press ʻ or ʼ button until the "Geometric" menu appears.
Ⱟ Press ˭ or ˮ button to highlight the item.
ⰱ Press Enter button to confirm and display a status bar as below.
ⰳ Press ʻ button to decrease that will soften the color. Press ʼ button to increase that will make white area more bright.
ⰵ Press Enter button to confirm the adjustment and return. 29