Alpine CDA-9886 User Manual - Page 9
Getting Started - setup
View all Alpine CDA-9886 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Getting Started Rotary encoder (OPEN) MUTE /ENT 3 Grasp the front panel firmly, slide to the left , and then pull to remove. SOURCE/ /ESC F/SETUP Accessory List • Head unit 1 • Power cable 1 • Mounting sleeve 1 • Carrying case 1 • Bracket key 2 • Screw (M5 × 8 4 • Remote Control 1 • Battery (AAA size 2 • Owner's Manual 1 set • The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel). This is not a malfunction. • To protect the front panel, place it in the supplied carrying case. • When detaching the front panel, do not apply excessive force as it may result in malfunction. • Do not leave the front panel open, or drive the car with the panel open as it may result in an accident or malfunction. Attaching 1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit. 2 Push the left side of the front panel until it locks firmly into the main unit. Turning Power On and Off Press SOURCE/ to turn on the unit. • The unit can be turned on by pressing any other button except (OPEN). Press and hold SOURCE/ for at least 2 seconds to turn off the unit. • The first time power is turned on, the volume will start from level 12. Detaching and Attaching the Front Panel Detaching 1 Turn off the unit power. 2 Press (OPEN) to open the front panel. • Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit. • Attach the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake. Initial System Start-Up Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc. 1 Turn off the unit power. 2 Press (OPEN) to open the front panel, and then remove it. 3 Press RESET with a ballpoint pen or similar pointed object. To close the front panel, press the left side until it locks as shown in the figure below. RESET switch 7-EN