Alpine CDE-143BT User Manual - Page 15

Sound Setting Rotary encoder /ENTER AUDIO/SETUP * The illustration is for CDE-SXM145BT/CDE-143BT. Adjusting Subwoofer Level/Bass Level/Mid Level/Treble Level/Balance (Between Left and Right)/Fader (Between Front and Rear)/ Defeat 1 Press AUDIOSETUP repeatedly to choose the desired mode. Each press changes the mode as follows: SUBWOOFER*1  BASS LEVEL*2  MID LEVEL*2  TRE LEVEL*2  BALANCE  FADER  DEFEAT  VOLUME  SUBWOOFER *1 When the SUBWOOFER mode is set to SUBW OFF, its level cannot be adjusted. *2 Adjustable only when DEFEAT is DEFEAT OFF. Subwoofer Bass level Mid level Treble level Balance Fader Defeat Volume +0 ~ +15 -7 ~ +7 -7 ~ +7 -7 ~ +7 L15 ~ R15 R15 ~ F15 ON/OFF 0 ~ 35 Note • If no operation is performed for 5 seconds, the unit automatically returns to normal mode. 2 Turn the Rotary encoder until the desired sound is obtained in each mode. By setting DEFEAT ON, previously adjusted settings of BASS, MID and TRE LEVEL will return to the factory defaults. Audio Setup You can flexibly customize the unit to suit your own preference and usage. From the AUDIO SETUP menu, Audio Setting can be modified. Use steps 1 to 5 to select one of the setting modes to modify. See the applicable section below for details about the selected setting item. 1 Press and hold AUDIOSETUP for at least 2 seconds to activate the SETUP mode. 2 Turn the Rotary encoder to select AUDIO, and then press ENTER. AUDIO  GENERAL  DISPLAY  TUNER  SIRIUSXM*1  iPod  BLUETOOTH *1 Displayed only when a siriusXM Tuner is connected.(CDE-SXM145BT only). 3 Turn the Rotary encoder to select the desired sound setting menu, and then press ENTER. FACTORY EQ*2/*3  3BAND EQ*2/*4  VOL LV ADJ  HPF*2  SUBWOOFER  SUBW LPF*2/*5  SUBW PHASE*5  SUBW SYS*5  POWER IC  MX SETTING*2 (e.g. Select SUBWOOFER) *2 Adjustment cannot be performed when DEFEAT is set to ON. *3 Any changes made to either FACTORY EQ or 3BAND EQ are reflected in the others' settings. *4 In step 3, three sound adjustment items (Bass, Mid and Treble) can be selected in 3BAND EQ mode. Turn the Rotary encoder to select the desired item, and then press ENTER to continue to step 4. *5 These functions are inoperable when SUBWOOFER is set to SUBW OFF. 4 Turn the Rotary encoder to change the setting, and then press ENTER. (e.g. Select SUBW ON or SUBW OFF) 5 Press and hold AUDIOSETUP for at least 2 seconds to return to normal mode. Notes • Pressing r returns to the previous Sound menu mode. • Pressing and holding r for at least 2 seconds will return to normal mode. • If no operation is performed for 60 seconds, Sound menu mode is canceled. Equalizer Presets (F-EQ) 10 typical equalizer settings are preset at the factory for a variety of musical source material. USER settings are created in the 3BAND EQ mode.  Setting item: FACTORY EQ Setting contents: USER / FLAT (Initial setting) / POPS / ROCK / NEWS / JAZZ / ELEC DANCE / HIP HOP / EASY LIS / COUNTRY / CLASSICAL 15-EN