Amana AGR4230BAW Installation Guide - Page 13

2. Remove the cap from the gas pressure regulator using a flat-blade screwdriver. NOTE: Be sure sealing washer remains in the same position. A 4. Install LP gas orifice spuds using a 7 mm combination wrench. A A. Cap 3. To convert to LP gas, unscrew the plastic adjustment screw by hand, turn it over, and screw it in again. Inlet pressure Inlet pressure to Natural gas to LP gas A B C 180º A. Cap B. Sealing washer C. Adjustment screw 4. Reinstall the cap. To Convert Surface Burners 1. Remove burner grate, burner caps, and burners. B A. Spud B. Holder NOTE: The range is equipped with 3 standard burners and 1 simmer burner (right rear). A B A. Burner cap B. Burner 2. Locate LP gas orifice spuds for top burners in the bag containing literature included with the range. Three LP gas spuds are stamped "88," and one is stamped "70 (Yellow/ White)." 3. Remove Natural gas orifice spuds using a 7 mm combination wrench. A. Standard burner - LP gas orifice spud number 88 B. Standard burner - LP gas orifice spud number 88 C. Simmer burner - LP gas orifice spud number 70 (Yellow/White) D. Standard burner - LP gas orifice spud number 88 5. Place the Natural gas orifice spuds in the parts bag for future use and keep with the bag containing literature. 6. Reinstall burners, burner caps, and burner grates. To Convert Oven Burner 1. Open the oven door and remove oven racks and oven tray with flame spreader, and set aside. 2. Remove screw from the oven burner. Lift oven burner and pull the burner toward you. The orifice spud is behind the oven burner air shutter. A B C A. Oven burner B. Air shutter C. Screw 13