Amana AGR4230BAW Installation Guide - Page 15

2. Remove the cap from the gas pressure regulator using a flat-blade screwdriver. NOTE: Make sure sealing washer remains in the same position. A 2. Locate Natural gas orifice spuds for top burners in the bag containing literature included with the range. Three Natural gas spuds are stamped "149," and one is stamped "110 (Red/Brass)." 3. Remove the LP gas orifice spuds using a 7 mm combination wrench. 4. Install the Natural gas orifice spuds using a 7 mm combination wrench. A. Cap 3. To convert to Natural gas, unscrew the plastic adjustment screw by hand, turn it over, and screw it in again. Inlet pressure to LP gas Inlet pressure to Natural gas A B 180º C A. Cap B. Sealing washer C. Adjustment screw 4. Reinstall the cap. To Convert Surface Burners 1. Remove burner grate, burner caps and burners. A B A. Spud B. Holder NOTE: The range is equipped with 3 standard burners and 1 simmer burner (right rear). A B A. Burner cap B. Burner A. Standard burner - Natural gas orifice spud number 149 B. Standard burner - Natural gas orifice spud number 149 C. Simmer burner - Natural gas orifice spud number 110 (Red/Brass) D. Standard burner - Natural gas orifice spud number 149 5. Place LP gas orifice spuds in the parts bag for future use and keep with the bag containing literature. 6. Reinstall burners, burner caps, and burner grates. 15