Amana ASI2575GRW use - Page 5

. Removing and Replacing the Ice Storage Bin: 1. Pull the covering panel up from the bottom. 2. Lift the plastic shutoff arm so it clicks into the Off (up) position. 3. Lift up the front of the storage bin and pull it out. 4. Replace the bin by pushing it in all the way or the dispenser will not work. 5. To restart ice production, lower the plastic shutoff arm into the On (down) position. Make sure that door is closed tightly. Water Filtration System Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. 3. Take the new filter out of its packaging and remove the covers from the O-rings. Be sure the O-rings are still in place after the covers are removed. 4. With the arrow pointing to the left (toward the filter cover door's hinge), align the new filter with the filter housing and slide it into place. The filter cover door will automatically begin to close as the new filter is inserted. 5. Close the filter cover door completely in order to snap the filter into place. You may need to press hard. 6. Flush the water system. See the "Water and Ice Dispensers" section. Style 2 1. Locate the water filter cover door in the base grille, and pull open the filter door. Water Filter Status Light (on some models) The filter status light will help you know when to change your water filter, this is located in the refrigerator control panel. ■■ The light will turn on red. This tells you that it is almost time to change the filter. ■■ It is recommended that you replace the filter when the status light changes to red or water flow to your water dispenser or ice maker decreases noticeably. NOTE: The filter should be replaced at least every six months depending on your water quality and usage. Resetting the Filter Status ■■ The reset button is located on the control panel in the refrigerator compartment. To reset the status light after changing the filter, press the button TEMP SETTING within 3 seconds. The status light will change from red to off when the system is reset. Changing the Water Filter Style 1 1. Locate the water filter cover door in the base grille, and pull open the filter door. The filter will be released and then be ejected as the door is opened. A A. Water filter cover door 2. Twist the water filter and turn 90° counterclockwise to unlock. 3. Pull the filter out of the housing. A A. Water filter cover door 2. When the door is completely open, pull the filter straight out. NOTE: There may be some water in the filter. Some spilling may occur. Use a towel to wipe up any spills. 4. Remove the water filter cap from the water filter. 5