Apple M8840LL/A Setup Guide - Page 12
system to which you will be connecting.
UPC - 718908440841
View all Apple M8840LL/A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Plugging In the Computer Before you plug your Macintosh into a wall socket, carefully read all the setup instructions in this chapter. Then, before you connect any other equipment, follow the instructions in this section to plug it in. When you are ready to begin, follow these steps: 1 Make sure the voltage switch on the back of the computer is set for the kind of voltage system to which you will be connecting. Check to see that the voltage switch on the back of your computer is properly set before you plug it in. If you need to change the setting, insert a small screwdriver in this slot and slide the switch. Set the switch to show "115" for AC voltages in the 100-120 V range. Set the switch to show "230" for AC voltages in the 200-240 V range. The voltage switch must be set correctly to avoid damaging your computer. An adhesive label showing how to set the voltage may partly cover the voltage switch and power socket. Remove the label. Look at the table "Voltage Switch Settings for Different Locations," next. 12 Chapter 1