Ariens Deluxe 30 Owners Manual - Page 32
Install New Attachment Drive Belts, TRACTION DRIVE BELT, REPLACEMENT, NOTICE, IMPORTANT
View all Ariens Deluxe 30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
921023, 024, 030, 032, 035 2 3 1 1 2 4 921028, 029 2 3 1 4 1. Belt Cover 2. Chute Gear Cover 3. Discharge Chute Rod 4. Chute Lock Cable Figure 38 Install New Attachment Drive Belts 1. Place new attachment belts onto attachment pulley. NOTICE: Holding down the attachment clutch lever will make it easier to reconnect the housing and frame. 2. Tip housing and frame back together and secure with hex bolts. 3. Place belts onto engine sheave. 4. Reposition and secure belt finger. IMPORTANT: With attachment clutch lever engaged, belt finger on the side opposite the belt idler should be less than 1/8" (3 mm) from belt, but not touching the belt. Adjust belt finger as necessary. 7 3 5 6 1. Traction Drive Belt 2. Engine Sheave 3. Attachment Drive Belts 4. Belt Finger 5. Attachment Belt Idler 6. Attachment Idler Adjustment Nut 7. Traction Belt Idler Figure 39 5. Check adjustment. See Attachment Clutch/Brake Adjustment on page 29. WARNING: AUGER / IMPELLER MUST STOP within 5 seconds when attachment clutch lever is released or unit damage or serious injury may result. 6. Reconnect chute lock cable, chute deflector cap cable, chute crank and secure. 7. 921028, 029: Reinstall chute gear cover. 8. Replace belt cover and tighten hardware. TRACTION DRIVE BELT REPLACEMENT NOTICE: Replacement will be easier with housing and frame tipped apart and bottom cover off. 1. Remove attachment drive belts (see Remove old attachment drive belts: on page 31). 2. Detach traction idler spring. 3. Remove swing gate spacer and slide drive plate over so that finger clears stop hole in frame and can swing past it (Figure 40). NOTICE: The drive plate is detached to create space between the drive plate and friction disc to remove and reinstall the belt. EN - 32