Ariens Pro 21 Owners Manual - Page 15
MOWING TIPS, Manual Start, Shut Off, Mulching Tips
View all Ariens Pro 21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Manual Start 1. Check each item in the Before Each Use section of the MAINTENANCE SCHEDULE on page 16. 2. Open fuel shutoff valve. 3. For engines with a primer, push primer bulb 2 or 3 times for a cold engine. NOTE: It is unnecessary to prime or choke a warm engine. 4. For engines with a throttle, place throttle control in the choke position. Once the engine has started, place throttle in the high speed detent. 5. With engine/blade control held against the handlebar, grasp starter handle and pull rope slowly until it pulls harder. This is the compression stroke. Let rope rewind slowly. 6. Pull rope with rapid continuous full arm stroke to start engine. Allow rope to rewind slowly. IMPORTANT: DO NOT let starter handle snap against bracket. 7. Repeat steps 4 and 6 until engine starts. (If engine does not start, see TROUBLESHOOTING on page 24.) Shut Off 1. Release wheel drive control and allow unit to stop completely (self-propelled models). 2. Release engine/blade control. MOWING TIPS Cut grass when it is dry. Keep mower blades sharp. Do not set cutting height too low. For tall grass, mow twice. Do not mow too fast. Mow with engine at full throttle. Discharge clippings into areas already cut. Vary cutting pattern with each mowing. NOTE: To prevent dirt and grass from collecting on mower pan, avoid operating over bare ground with only patches of grass. Mulching Tips For best mulching performance, cut no more than 1 inch (2.54 cm) of grass per cutting. GB - 15