Ariens Pro 21 Owners Manual - Page 23

STORAGE, Check the adjustment, To adjust, Cleaning, Inspection, Grass Bag, Engine

Get Ariens Pro 21 PDF manuals and user guides View all Ariens Pro 21 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

NOTE: Before adjusting the wheel drive cable, first make sure the area around the drive components is free of dirt or debris that could prevent the transmission from engaging or disengaging properly, and then make sure the return spring is connected properly to idler arm. Adjust the wheel drive by adjusting the cable on the handlebar. IMPORTANT: DO NOT adjust the cable so the transmission does not return to neutral and stop the unit when the control bail is released. Check the adjustment 1. Start the engine and slowly squeeze the wheel drive control against the handlebar and then release the wheel drive control. 2. The unit should move forward as you squeeze the wheel drive control and then stop immediately and not "creep" slowly forward when you release it. To adjust: 1. Move the wheel drive cable adjuster up or down the handlebar. See Figure 19. To increase traction and speed, move the cable adjuster down the handlebar. To decrease traction and speed, move the cable adjuster up the handlebar. 2. Check the adjustment and readjust as needed. Cable Adjuster Figure 19 STORAGE CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding. IMPORTANT: NEVER spray unit with highpressure water or store unit outdoors. Store mower in a cool, dry, protected location. Cleaning Allow unit to cool. Clean unit thoroughly with mild soap and low pressure water. Brush off dirt and debris from all surfaces. Touch up all scratched surfaces to prevent rust. Matching touch-up paint is available from your Ariens Dealer. Do not use abrasives, solvents, or harsh cleaners. Inspection Inspect mower and repair or replace worn or damaged parts to avoid delays when beginning use again. Regularly check all hardware and keep fasteners tight. Know unit is in safe working condition. Grass Bag Wash out grass bag and allow to dry before storage. Grass bag may be stored in position on mower. Engine When storing unit for extended periods of time, remove all fuel from tank and carburetor (run dry). Refer to engine manual. GB - 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
GB - 23
NOTE:
Before adjusting the wheel drive
cable, first make sure the area around the
drive components is free of dirt or debris that
could prevent the transmission from engaging
or disengaging properly, and then make sure
the return spring is connected properly to
idler arm.
Adjust the wheel drive by adjusting the cable
on the handlebar.
IMPORTANT:
DO NOT adjust the cable so
the transmission does not return to neutral
and stop the unit when the control bail is
released.
Check the adjustment
1. Start the engine and slowly squeeze the
wheel drive control against the
handlebar and then release the wheel
drive control.
2. The unit should move forward as you
squeeze the wheel drive control and
then stop immediately and not "creep"
slowly forward when you release it.
To adjust:
1. Move the wheel drive cable adjuster up
or down the handlebar. See Figure 19.
To increase traction and speed,
move
the cable adjuster down the handlebar.
To decrease traction and speed,
move
the cable adjuster up the handlebar.
2. Check the adjustment and readjust as
needed.
IMPORTANT:
NEVER spray unit with high-
pressure water or store unit outdoors. Store
mower in a cool, dry, protected location.
Cleaning
Allow unit to cool. Clean unit thoroughly with
mild soap and low pressure water. Brush off
dirt and debris from all surfaces. Touch up all
scratched surfaces to prevent rust. Matching
touch-up paint is available from your Ariens
Dealer. Do not use abrasives, solvents, or
harsh cleaners.
Inspection
Inspect mower and repair or replace worn or
damaged parts to avoid delays when
beginning use again.
Regularly check all hardware and keep
fasteners tight. Know unit is in safe working
condition.
Grass Bag
Wash out grass bag and allow to dry before
storage. Grass bag may be stored in position
on mower.
Engine
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to engine manual.
Figure 19
Cable Adjuster
STORAGE
CAUTION:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.