Ariens Pro Track 28 Owners Manual - Page 23
Service And Adjustments, Scraper Blade, Skid Shoes
View all Ariens Pro Track 28 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Replace Fuse (926104, 105) 1. Remove the two screws and the cover plate from beneath the battery. 3. Install a new fuse of the same amprating and type. OS7455 Fuse and fuse holder. Figure 20 Cover plate and mounting screws. Figure 19 OS7450 2. Locate the fuse holder on the wiring harness and remove the fuse. 4. Replace the cover plate and secure in position with the two screws removed in step 1. NOTE: Make sure the wire harness does not get pinched between the cover plate and the auger housing. SERVICE AND ADJUSTMENTS WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. SCRAPER BLADE IMPORTANT: Damage to auger/impeller housing will result if blade wears down too far. Scraper blade is adjustable to compensate for wear. To adjust scraper blade: 1. Tip unit back onto handlebar, support housing and loosen nuts retaining blade. 2. Adjust skid shoes to fully raised position (housing closest to ground). 3. Reposition scraper blade flush with skid shoes and tighten lock nuts. SKID SHOES (Figure 21) Skid Shoes should be adjusted as conditions require. 1. Position unit on a hard, flat, smooth level surface. 2. Adjust skid shoes by inserting a spacer of desired thickness under center of scraper blade, loosen skid shoe hardware, slide skid shoes to flat surface. Allow 1/8 in. (3 mm) between scraper blade and hard smooth surfaces. Allow 1 in. (25 mm) between scraper blade and uneven or gravel surfaces. Retighten hardware. NOTE: Keep housing level by adjusting skid shoes equally. 2 1 1. Skid Shoes 2. Skid Shoe Hardware Figure 21 OS0483 GB - 23