Ariens Zoom 42 Operation Manual

Ariens Zoom 42 Manual

Get Ariens Zoom 42 PDF manuals and user guides View all Ariens Zoom 42 manuals
Add to My Manuals
Save this manual to your list of manuals

Ariens Zoom 42 manual content summary:

  • Ariens Zoom 42 | Operation Manual - Page 1
    Zoom® Owner/Operator Manual Manuel Du Propriétaire/Utilisateur Models 915157 - Zoom 34 915159 - Zoom 42 915161 - Zoom 50 915169 - Zoom 34 CARB 915171 - Zoom 42 CARB Gasoline containing up to 10% ethanol (E10) or up to 10% MTBE (methyl tertiary butyl ether) is acceptable for use in this machine. The
  • Ariens Zoom 42 | Operation Manual - Page 2
    16 SERVICE AND ADJUSTMENTS . . . . . 17 STORAGE 24 TROUBLESHOOTING 25 SERVICE PARTS 26 ACCESSORIES 26 SPECIFICATIONS 27 WARRANTY 29 INTRODUCTION NON-ENGLISH MANUALS Manuals in languages other than English may be obtained from your Dealer. Visit your dealer or www.ariens.com for a list
  • Ariens Zoom 42 | Operation Manual - Page 3
    described within this manual may be optional. Some illustrations may not be applicable to your unit. UNAUTHORIZED REPLACEMENT PARTS Use only Ariens replacement parts. The replacement of any part on this unit with anything other than an Ariens authorized replacement part may adversely affect
  • Ariens Zoom 42 | Operation Manual - Page 4
    parts to stop before leaving operator's position. SAFETY ALERTS Look for these symbols to point out important safety precautions. They mean: • Attention! • Personal Safety Is Involved! • Become Alert! • Obey The Message! The safety alert symbol is used in decals and with this manual. Understand
  • Ariens Zoom 42 | Operation Manual - Page 5
    cap securely and clean up spilled fuel. OL1809 Always keep feet and hands away from rotating parts. OL1810 Always stand clear of discharge area. Do not direct discharge toward other people. Keep people away from unit while operating. OL18111 OL1812 Shut off engine, remove key, and read manual
  • Ariens Zoom 42 | Operation Manual - Page 6
    Company dealer or an authorized engine manufacturer's service center. Contact your Ariens Company Equipment Retailer concerning emission controls and component questions. SAFETY RULES If unit is to be used by someone other than original purchaser; loaned, rented or sold, ALWAYS provide this manual
  • Ariens Zoom 42 | Operation Manual - Page 7
    Read, understand, and follow all safety practices in Owner/Operator Manual before assembling, using or working on this mower. ALWAYS remove key from ignition and wire from spark plug before assembly, or working on this unit. Inspect unit before each use for: missing or damaged decals and shields,
  • Ariens Zoom 42 | Operation Manual - Page 8
    machine while engine is running. ALWAYS turn off power to attachment and properly drain fuel when transporting unit. Keep unit free of grass clippings, leaves, and other debris. Clean up oil or fuel spills. This product is equipped with an internal combustion type engine. DO NOT use unit on
  • Ariens Zoom 42 | Operation Manual - Page 9
    storage, clean unit thoroughly. See storage section and Engine Manual for proper storage. Use only attachments or accessories designed for your unit. Check attachment components frequently. If worn or damaged, replace with manufacturer's recommended parts. ASSEMBLY WARNING: AVOID INJURY. Read and
  • Ariens Zoom 42 | Operation Manual - Page 10
    ! Explosive separation of tire and rim parts is possible when they are serviced incorrectly: • Do not attempt to Use a clip-on chuck and extension hose long enough to allow you to stand to one side. See SPECIFICATIONS on page 27. Level Mower Deck See LEVELLING AND ADJUSTING PITCH OF MOWER DECK
  • Ariens Zoom 42 | Operation Manual - Page 11
    5 6 4 10 7 9 915157, 169 13 1 2 8 915159, 161, 171 11 12 1. Ignition Switch 2. PTO Switch 3. Seat 4. Fuel Level 5. Steering Levers 6. Fuel Tank 12 Figure 4 7. Mower Lift Pedal 8. Mower Deck 9. Discharge Chute 10. Parking Brake 11. Choke (915159, 161, 171) 12. Throttle (915159, 161, 171) 13
  • Ariens Zoom 42 | Operation Manual - Page 12
    lifts off seat. Ignition Switch Operate ignition switch with a removable key. Ignition switch has three positions: Stop (1), Run (2), Start (3). See STARTING AND SHUTTING OFF ENGINE on page 14 for detailed instructions on how to start engine. Throttle/Choke Lever (915157, 169) Choke (1) - Use
  • Ariens Zoom 42 | Operation Manual - Page 13
    . 4. Replace fuel cap and tighten. 5. ALWAYS clean up spilled fuel. GASOLINE IMPORTANT: ALWAYS use gasoline that meets the following guidelines: • Clean, fresh gasoline. • A minimum of 87 octane/87 AKI (91 RON). High altitude use may require a different octane. Consult your engine manual. • Gasoline
  • Ariens Zoom 42 | Operation Manual - Page 14
    the fuel hoses, filter and tank. Prevent Turn ignition switch to off position and remove key. 5. Set parking brake. OPERATING MOWER 1. Start engine. 2. Set throttle lever to fast. IMPORTANT: Never engage PTO if mower is plugged with grass or other material. 3. Engage PTO to start mower blades
  • Ariens Zoom 42 | Operation Manual - Page 15
    BEST PERFORMANCE Cut grass when it is dry. Keep mower blades sharp. Keep mower deck properly leveled. Do not set height of cut too low. For very tall grass, mow twice. Do not travel too fast. Mow with the engine set at full throttle. When mulching, only remove one-third of grass length per cutting
  • Ariens Zoom 42 | Operation Manual - Page 16
    brake and engage transmission bypass lever (see MOVING UNIT MANUALLY on page 15). Push unit. If unit rolls, contact your Ariens Dealer. Clean Unit Clean engine, battery, seat, mower deck, etc. of all dirt and debris. Do not use solvents, hard cleaners, or abrasives. NOTE: Protect painted surfaces
  • Ariens Zoom 42 | Operation Manual - Page 17
    Keep battery and battery terminals clean (see Cleaning Battery and Battery Battery Cables on page 21). Lubricate Apply grease to zerk (1) on each Unit front wheel 25 Hours or Every Season 1 50 Hours Check Check mower blade mounting hardware and all other fasteners. or Every Fasteners Replace
  • Ariens Zoom 42 | Operation Manual - Page 18
    and rear trunnions to lift arms. 4. Install PTO belt on the engine drive pulley (see REPLACING PTO BELT on page 23). 5. Level and adjust pitch of mower deck (see LEVELLING AND ADJUSTING PITCH OF MOWER DECK on page 18). 6 5 4 3 2 1. Rear Trunnion 2. PTO Belt 3. Mower Deck 4. Drag Link 5. Front
  • Ariens Zoom 42 | Operation Manual - Page 19
    11 REPLACING MOWER BLADE Remove (Figure 12) CAUTION: Mower blades are sharp and can cut you. Wrap the blades or wear gloves, and use extra caution when servicing them. 1/4-in. (6.35 mm) from Side-To-Side 1. Mower Deck 2. Mower Blade 3. Ground Figure 10 Adjusting The Mower Deck To Adjust Mower
  • Ariens Zoom 42 | Operation Manual - Page 20
    mower blade from unit (see REPLACING MOWER BLADE on page 19). Ariens recommends having mower blades sharpened by a professional. Contact your Ariens dealer. Discard mower blade if (figure 13): • more than 1/2 in. (1.27 cm) of metal is removed. • the air lift erosion area is eroded. • the mower blade
  • Ariens Zoom 42 | Operation Manual - Page 21
    to battery charger and battery manufacturers' instructions. 5. Install battery on unit (see Battery Removal and Installation on page 20). Jump-Starting Ariens does not recommend jump-starting your unit. Jump-starting can damage engine and electrical system components. See your engine manual for
  • Ariens Zoom 42 | Operation Manual - Page 22
    16). Rotate this end away from the operator position to move the steering levers out. Figure 16 see your Dealer for repair turns toward indicates that the wheel on that side is turning slower than the other wheel. Either the wheel that is turning faster needs to slow down or the wheel that is turning
  • Ariens Zoom 42 | Operation Manual - Page 23
    17 REPLACING PTO BELT Remove (Figure 18) 1. Lower mower deck to the ground. 2. Remove belt covers from mower deck. CAUTION: Use care when releasing idler spring tension. Keep body parts well away from idler when performing this operation. 4 2 1. Deck Spindle 2. Engine Drive Pulley 3. Deck Idler
  • Ariens Zoom 42 | Operation Manual - Page 24
    pulley rests firmly against PTO belt. 4. Install belt covers on mower deck. NOTE: Ensure that belt is still positioned in the groove of the sheave after belt covers are installed. REPLACING HYDROSTATIC BELT Remove (Figure 20) 1. Remove PTO belt (see REPLACING PTO BELT on page 23). 2. Connect idler
  • Ariens Zoom 42 | Operation Manual - Page 25
    battery and battery cables (see Cleaning Battery and Battery Cables on page 21). 5. Connect spark plug wire(s) or replace spark plug(s). Refer to Engine Manual for detailed instructions. 6. Contact your Ariens Dealer. 7. Contact your Ariens Dealer. 1. Disengage choke. 2. Clean or replace air filter
  • Ariens Zoom 42 | Operation Manual - Page 26
    Belt 03971900 50-Inch Mower Blade 07200524 50-Inch Deck Belt ACCESSORIES See your authorized Ariens dealer to add these optional accessories to your unit. Part No. Description 71503300 36-Inch Roller 71503400 48-Inch Dethatcher 71503600 Spreader 71508200 48-Inch Aerator 71510800 34-Inch Mulch Kit
  • Ariens Zoom 42 | Operation Manual - Page 27
    34 Zoom 42 Zoom 50 Engine Type Briggs & Stratton Kohler Kohler Engine Displacement in.3 (cc) 30.51 (500) 44 (725) 44 (725) Governed RPM (May be different from maximum RPM) 3600 + 0 3600 - 100 Drive Forward Max. - m.p.h (km/h) 6.0 (9.6) Reverse Max. - m.p.h (km/h) 3.0 (4.8) Turning
  • Ariens Zoom 42 | Operation Manual - Page 28
    Model Zoom 34 CARB Zoom 42 CARB Engine Type Briggs & Stratton Kohler Engine Displacement in.3 (cc) 30.51 (500) 44 (725) Governed RPM (May be different from maximum RPM) 3600 + 0 3600 - 100 Drive Forward Max. - m.p.h (km/h) 6.0 (9.6) Reverse Max. - m.p.h (km/h) 3.0 (4.8) Turning
  • Ariens Zoom 42 | Operation Manual - Page 29
    and exclusions set forth herein. Such repair or replacement will be free of charge (labor and parts) to the original purchaser except as noted below. Five-Year Limited Warranty on Mower Deck Shell The deck shell on zero-turn riding mowers is warranted to the original purchaser for five years
  • Ariens Zoom 42 | Operation Manual - Page 30
    Warranty • Engines and engine accessories are covered only by the engine manufacturer's warranty and are not covered by this warranty. • Parts that are not genuine Ariens, Gravely or Countax service parts are not covered by this warranty. • The following maintenance, service and replacement items
  • Ariens Zoom 42 | Operation Manual - Page 31
    equipment is defective, the part will be repaired or replaced by Ariens Company. OWNER'S WARRANTY RESPONSIBILITIES: • As the small off-road equipment owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. Ariens Company recommends that you retain
  • Ariens Zoom 42 | Operation Manual - Page 32
    Disclaimer New equipment sold in the state of California that uses small off-road engines must be exclusively certified and appropriately labeled for sale in California. Some equipment covered by this Owner's Manual my not be certified for sale in California and the presence of the preceding CARB
  • Ariens Zoom 42 | Operation Manual - Page 33
    Ariens Company 655 West Ryan Street Brillion, WI 54110-1072 920-756-4688 Fax 920-756-2407 www.ariens.com
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
Owner/Operator Manual
Manuel Du Propriétaire/Utilisateur
Zoom
®
03997700B 1/11
Printed in USA
ENGLISH
FRANÇAIS
Models
915157 – Zoom 34
915159 – Zoom 42
915161 – Zoom 50
915169 – Zoom 34 CARB
915171 – Zoom 42 CARB
Gasoline containing up to 10% ethanol (E10) or up to 10% MTBE (methyl tertiary butyl ether) is
acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) or 10% MTBE will void the product warranty.
Il est possible d’utiliser de l’essence contenant jusqu’à 10% d’éthanol (E10) ou 10% de MTBE
(éther méthyl-tertiobutylique) sur cette machine.
L’utilisation d’une essence contenant plus de 10% d’éthanol (E10) ou de 10% de MTBE annulent la
garantie.