Asko T712C User manual Quick Start Guide T712C EN - Page 15

Troubleshooting The machine will not start Check • that the outer door is properly closed. • that the main power switch is pressed. • that you have set the program correctly. • that the Delayed Start option has not been selected. If so, the time remaining until start will be shown in full hours in the display (e.g. 5, 4, 3h) . • that any plug is connected. • that your home's fuses (circuit breakers) are intact, swap two circuit breakers. You cannot always tell from outside if a circuit breaker is broken. • that the overheating cut-off has not been triggered (see below). Overheating cut-off The overheating cut-off shuts off the tumble dryer if the temperature is too high, caused by lint clogging the lint filter, for instance. • Clean the filter. • Check to see if the lint filter is dirty and clean it if necessary. See "Care and cleaning". • The overheating cut-off will reset automatically once the machine has cooled. Drying takes too long • Check that neither the lint filter nor the condenser are clogged. See "Care and cleaning". • Prolonged drying times may also be due to the condenser dryer being placed in a room that is too small and the air in the room (cooling air) being too hot. • Make sure that the tumble dryer has access to more cold air, by opening doors and/or windows, for example. Error messages • If F1 flashes in the display, the condenser drain hose could be blocked. Remove the hose from the drain and check for obstructions. The hose should be inserted no more than 5 or 6 inches into the wall drain. • If F2 flashes in the display, the maximum permitted program time has been reached. For remedial action, read "Drying takes too long" in the "Troubleshooting" section. Custumer Care Center 1-800-898-1879 15 www.askousa.com