Asko T712C User manual Quick Start Guide T712C EN - Page 19
Installation instructions
View all Asko T712C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation instructions Positioning the tumble dryer The tumble dryer can be installed freestanding or stacked. Remember that the tumble dryer produces heat and should therefore not be located in a room that is too small. If the room is very small, drying will take longer due to the limited quantity of air. Caution! The machine must not be installed behind a lockable door, a sliding door or a door with hinges on the opposite side to those of the tumble dryer. Advice! To improve ventilation, the door to the room where the tumble dryer is located should be left open. Caution! Any electrical installation should be carried out by qualified professionals. A. Freestanding The tumble dryer can be positioned beside the washing machine. B. Stacking The tumble dryer can be placed on top of an Asko washing machine. To stack the dryer, you need to the stacking attachments that come with the machine. There will be: 2 foot cups. These can be found in a bag in the drum. 2 anti-tip devices. These come attached to the bottom left corner on the back of the machine. C. Built-in ASKO dryers can be installed beneath a cabinet or worktop with a minimum height of 34" (864 mm). There must be a gap of about 1/2" (12 mm) all around the machine, including between the rear edge of the machine top panel and the back wall. The opening width must be at least 24-1/2" (622 mm). The condensing models work best when they have good air circulation. Therefore, we don't recommend they be installed beneath a cabinet. If it is necessary, however, be sure to leave a gap of at least 1/2" (12 mm) on all sides. Install the dryer so the condensed water will continuously flow into a drain or sink, you will need a drain outlet behind the unit. The maximum drain height is 40" (1016 mm). NOTES: The height adjustment for the dryer is 33-1/2" to 34-1/2" (850 mm to 876 mm). Do not raise it higher than 34-1/2". Hole measurements are from center of hole. Custumer Care Center 1-800-898-1879 19 www.askousa.com